Remote Control; Care And Cleaning - AEG DGE5161HM Benutzerinformation

It is recommended to leave
the hood operating for
approximately 15 minutes
after cooking.
To operate the hood:
1. Press the first speed button
switch on the appliance.
2. If needed, press the light button
illuminate the cooking surface.
3. If needed, change the speed by
pressing the desired button.
To turn off the appliance press the first
speed button
3.2 Hob²Hood function
It is an automatic function which
connects the hob with a hood. Both the
hob and the hood have an infrared signal
communicator. Speed of the fan is
defined automatically on basis of mode
setting and temperature of the hottest
cookware on the hob. You can also
operate the fan using the hob manually.
The function can be activated from panel
of the hob.
For more information how to
use the function refer to the
hob user manual.
3.3 Filter notification
Filter alarm reminds to change or clean
the charcoal filter and clean the grease
filter. The filter indicator
for 30 seconds if the grease filter must
be cleaned. The filter indicator

4. CARE AND CLEANING

4.1 Notes on cleaning
Cleaning
Agents
to
again.
is turned on
flashes
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water
and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains ap‐
pliance must be cooled down and dried with clean cloth or paper tow‐
els.
Clean stains with a mild detergent.
for 30 seconds if the charcoal filter must
be replaced or cleaned.
Refer to cleaning the grease
filter in care and cleaning
chapter.
Refer to cleaning the
charcoal filter or replacing
the charcoal filter in care and
to
cleaning chapter.
To reset the function press the button
for 3 seconds.
To activate or deactivate function:
1. To activate function press the button
for 3 seconds.
If the function is activated, the indicator
flashes two times.
2. To deactivate function press the
button
If the function is deactivated, the
indicator flashes ones.
3.4 Remote-control
The appliance is supplied with a remote-
control.
The connection is originally enabled.
To connect or disconnect remote-
control:
1. Switch off the appliance.
2. Press the
The indicator on control panel flashes
twice if function is enabled and once if
disabled.
ENGLISH
for 3 seconds.
for 3 seconds.
29