Remote Control - AEG X95254MI1 Gebrauchsanleitung

www.aeg.com
4
4. CONTROLS
Button
L
T1
Warning: The Hood controls only control the Hood
functions. The Lighting unit has a com-pletely
separate power supply and a separate switch.
The electronic control system recognises and
signals two types of fault
Led T1
Slow flashing
Rapid flashing
L T1 T2
Function Display
Turns the lights -
On/Off.
Hood Down On/Off
Press for 2 seconds
to raise the Hood.
Press briefly to turn
the Motor On/Off.
Hood Up Off/Off
Press once: The
Hood lowers.
Press a second
time: The Hood
Stops.
When the move-
ment has been
completed the
motor turns on at
Speed two.
Current absorption threshold exceeded:
If an overload condition occurs, the fault
is signalled by LED T1 on the keyboard
flashing once every 2 seconds. Check
that nothing is blocking normal hood mo-
vements.The signal remains active until a
new hood open/close command is given.
Hood opening safety microswitch tripped:
If the safety microswitch trips, the fault
is signalled by LED T1 on the keyboard
flashing quickly (once every 250 ms). This
means that the hood has passed the mi-
croswitch........ Call Technical Assistance!
You can continue to use the hood's light
and motor functions while this fault is
active. Whenever the motor is on, LED T1
will continue to flash, indicating that the
fault is still present.

5. REMOTE CONTROL

S1
The appliance can be controlled using a remote
control powered by a 1.5 V carbon-zinc alkaline
batteries of the standard LR03-AAA type (not
T3 T4
included).
• Do not place the remote control near to heat
sources.
• Used batteries must be disposed of in the
proper manner.