Parental Lock - kqueo K-LIFT X2 Montageanleitung

6. Toggle between cm and inch units of measurement
To toggle between the cm and inch units of measurement, follow the steps below:
a. Press the "M" and "1" buttons simultaneously for 3 seconds.
b. The screen will start flashing and "C-E" will be displayed.
c. Press the "1" button within 10 seconds, "C" will appear on the display and the
system will operate in centimeters; press the "2" button,
"E" will be displayed and the system will operate in inches.
d. The display stops flashing and the toggling between centimeters and inches is
complete.
7. Setting the retraction height on the control box
Press the "DOWN" key on the keyboard until the base reaches its lowest position.
Measure the height of the base from the ground and check that the height shown
on the LED display corresponds to your measurement, if you need to adjust the
height shown on the display, follow the steps below:
a. Press and hold down the "DOWN" key (about 5 seconds) until the height is dis-
played on the LED screen flashing.
b. Press the "UP" or "DOWN" button to increase or decrease the displayed indica-
tion (1 unit per click).
c. Then press the "M" key and the LED display will stop flashing, your desk is now
ready.
Note: The LED display has a tolerance of 0.1 unit.

8. Parental lock

Press and hold the 3 and 4 buttons at the same time for 3 seconds to activate the
parental lock. The control panel will become inactive and the buttons will no longer
respond.
To deactivate the parental lock, press and hold the 3 and 4 buttons again for 3 sec-
onds and the panel will become active again.
20