Part 7- Offline Controller - Genmitsu 3018-PROVer V2 Benutzerhandbuch

Part 7- Offline Controller

The offline interface is designed according to our offline controller and does not match with other companies' offline
controllers.Do not connect other devices or controllers, or risk damaging the control board or other devices.
1. Button Functions Introduction
X-
Z+
Z-
Y-
Y+
Marker Instruction
Manual moving distance option (xC, x0.01, x0.1, x1) in xC mode,
press the key to keep moving; x0.01 means press the manual
STEP button once and the machine moves 0.01mm; x0.1means press
the manual button once and the machine moves 0.1mm;
x1 means press the button once and the machine moves 1mm;
Select Move cursor
Save/confirm/pause/start/return to main interface (long press),
Enter
X+
release (long press) limit switch to trigger alarm
X+ X+move, parameter modification (in setting state)
X- X-move, parameter modification (in setting state)
Y+ Y+move, parameter modification (in setting state)
Y- Y-move, parameter modification (in setting state)
Z+
Z+move
Z- Z-move
29