Symbols Used In Safety Instructions; General Safety Instructions - gumpo Contec plus Bedienungsanleitung

1.1 Symbols used in safety instructions

5.3 Click-Codes
This user manual contains safety instructions with symbols drawing your attention to possible dangers and residual
As soon as the desk system is supplied with electricity, the control unit uses the in-built relays to audibly inform the
risks. They indicate the following:
user about the status of the system. The following table shows the number of audible clicks and their corresponding
status information.
Number of clicks
2x with a short interval
1x
2x with a long interval
3x with a short interval
3x with a long interval
4x – 6x
6. Ergonomics
Desk systems which enable easy and quick switching between sitting and standing promote health and
well-being to a considerable degree and have a positive effect on the cognitive performance of office
workers. Alternate sitting and standing positions help avoid painful muscle and joint conditions while at
the same time influencing the cardiovascular system in a positive way.
1.2

General safety instructions

An ergonomic working posture is attained, if the working height is adapted to the body measurements of
the individual user. The working height, both in the sitting position and standing, should be at around
elbow height, with the upper arms in a relaxed hanging posture.
Caution: The system may only be operated with mains voltage as specified on the type plate. The system
is in operation as soon as the mains supply is connected.
Caution: Ensure that the mains cable is not damaged. Electric supply cables may not be exposed to
danger of pinching, or bending or pulling stresses.
The cable connectors on the control unit must not be detached.
Caution: In the event of a malfunction (e.g. if the control unit keeps adjusting the desk because a
movement key has jammed), please unplug the unit immediately from the mains supply.
Danger: Do not expose the electrical components to moisture, drips or splashes.
For more detailed information about ergonomics in the office contact your professional association and
your health insurance company, or you can simply contact us.
Caution: In the event of malfunction, as for example the development of smoke, smells, unusual
gumpo GmbH
noises, or visible external damage, the equipment must be switched off. Disconnect the unit
Gobener Weg 27 D-84130 Dingolfing Telephone +49(0)8731/706-000,
immediately from the mains supply.
Fax +49(0)8731/706-099 www.gumpo.de
26
Danger: This warning symbol advises you of imminent danger to people's lives and health.
Failure to observe this warning may result in health problems, serious injuries and damage to
property.
Caution: This warning advises you of possible dangers from electric current.
Failure to observe this warning may cause injuries and damage to property.
Note: This symbol advises you of important information that must be noted for operating the
unit safely.
Danger: This symbol advises you of a possible risk of body parts being trapped or pinched in
exceptional cases.
Failure to observe this warning may result in health problems, life-threatening injuries and
damage to property.
Note: You must read the user manual.
Status indicated
Normal operation:
The system is working without any problems.
Emergency mode:
The system is in emergency mode and the drives cannot be
used. Check the error code on the display of the hand switch.
Reset mode:
The system is in reset mode.
This signal will always sound, when an inadmissible key is
pressed in reset mode.
Collision protection inactive:
Due to a fault the collision protection is inactive.
Duty cycle limit reached:
The control unit cannot be used in order to allow it to cool down.
Last shutdown incomplete / Forced reset:
Check the error code on the display of the hand switch.
E-Mail: kontakt@gumpo.de
th
As of: 17 November 2014