IN & OUT HOUSE EF449A Bedienungsanleitung Seite 44

EN
I C O N T I T L E
STANDBY
FLAME
BRIGHTNESS
HEATING
TEMPERATURE
7 DAYS TIMER
TIMER
TIME
44
F U N C T I O N
Press to turn on/off the flame
effects and heater.
Cycle through 9 flame colours
and off setting.
Cycle through 5 settings of bright-
ness of flame and fuel bed.
Cycle through low heater, high
heater and off setting.
Adjust the heater's response to
the ambient temperature condi-
tions in the room. Temperature
adjusts from 16 °C - 28 °C (60 °F -
84 °F) and then 58 °C (99 °F).
Hold for 3 seconds to switch
between °C/°F.
Press to turn on/off 7 days timer.
Keep pressing to start the setting
for 7 days timer.
Set the time desired for the
fireplace to run. The timer can be
set from 0.5 hour up to nine (9)
hours in one (1) hour increments.
Press to set up the heating start
and end time under 7 days timer.
Keep pressing to set current time.
FI R E PL AC E R E S PO N S E
Turn on: F1, ..., F9, F0
Turn off: no display
F1, F2, ..., F0
L5, L4, L3, L2, L1, L0
LO = low heat setting
HI = high heat setting
The heater indicator will turn
off after 10 seconds if the
flame effect is on.
16, 17, 18, 19, 20, 21, 22, 23,
24, 25, 26, 27, 28, 58 in °C
60, 62, 64, 66, 68, 70, 72, 74,
76, 78, 80, 82, 84, 99 in °F
Indicator lights on.
30, 1H, 2H, 3H, 4H, 5H,
6H, 7H, 8H, 9H, 0H
The number shows on the
display.