Creality Sermoon D3 Schnellstartanleitung Seite 4

1. Remove the top foam.
2
1
4. Lift the transparent cover in
order and then remove it in a
horizontal position.
7. After switching on the power,
click on "Confirm" and lift the
printing platform.
Move the
extruder
2
3
Remove the
belt fasteners
2. Remove the belt fasteners and
move the extruder kit in the
order shown.
3
1
5. Remove the foam tray at the
bottom of the transparent cover
in the order shown in the figure.
A
3
1
8. Remove the bottom foam A
from the platform in order
shown in the figure.
1
Remove the
belt fasteners
3. Remove the foam that holds the
Extruder.
2
6. Switch on the power.
3
2
9. Remove foam B from the bottom
of the platform in order shown
and click on "Confirm".
B
1
2