Other Faults - Hoover H-DISH 300 Bedienungsanleitung

ERROR E21
display) with a short
audio signal
Any other code
(with display)
Only models without a display
If malfunctions or faults occur when a programme is running, the indicator light that
corresponds to the selected cycle will blink rapidly, and an intermittent audio signal will
sound. In this case, turn the dishwasher off by pressing the "ON/OFF" button.
After checking to make sure the water supply is open, that the drain pipe is not bent
and that the siphon or filters are not clogged, set the selected program again.
If the fault persists, contact the Technical Assistance Centre.
This dishwasher is equipped with an overflow safety device that, in the event of a
problem, automatically discharges any excess water.
WARNING
To ensure the correct operation of the overflow safety device, we
recommend not moving or tilting the dishwasher during operation.
Should it be necessary to tilt or move the dishwasher, please
ensure that the washing cycle is complete and that no water
remains inside the appliance.

Other faults

FAULTS
1. No programme
works
2. Dishwasher
does not fill
with water
Uncontrolled water supply with open solenoid valve.
(with
Close the water tap immediately and disconnect the appliance from
the power supply.
Turn off and unplug the dishwasher, wait a minute. Turn on the
machine and restart a program. If the error occurs again contact an
Authorised Customer Service Centre directly.
CAUSE
Plug not connected to wall socket
O/I button not pressed
Door is open
No electricity
See point 1
The water tap is closed
The water supply hose is bent
The filter of the water supply
hose is clogged
Connect electric plug
Press button
Close door
Check
Check
Open the water tap
Eliminate the bends in the hose
Clean the filter at the end of the
hose
127
SOLUTION