Water Softener Unit - Hoover H-DISH 300 Bedienungsanleitung

18. WATER SOFTENER
UNIT
Depending on the source of the supply,
water contains
limestone and minerals which are deposited
on the dishes leaving whitish stains and
marks. The higher the level of these
minerals present in the water, the harder
the water is.
The dishwasher is fitted with a water
softener unit which, through the use of
special regenerating salt, supplies softened
water for washing the dishes. The degree of
hardness of your water can be obtained
from your water supply company.
Regulating the water softener
Hardness of up to 90°fH (French grading) or
50°dH (German grading) through 6 different
settings. The table below lists different
degrees of water
corresponding setting for the softener unit.
Water
hardness
S0 0-5 0-3
S1 6-15 4-9
S2 16-30 10-16
*S3 31-45 17-25
S4 46-60 26-33
S5 61-90 34-50
* The water softener unit is set in the
factory at level 3, as this is suitable for
the majority of users.
varying amounts
hardness with
No indicator
NO
lights
YES P1
YES P1+P2
YES P1+P2+P3
P1+P2+P3+
YES
P4
P1+P2+P3+
YES
P4+P5
According to the degree of hardness of your
of
water, regulate the softener unit in the
following way:
The dishwasher must ALWAYS be off
before start of this procedure.
1. Turn on the dishwasher by holding the
"ON/OFF"
3 seconds.
2. Hold the "SETTING"
seconds to open the menu. When you
enter the settings mode, there will be 6
flashes from several of the indicator
lights on the dashboard.
3. Press the "PROGRAMME SELECTION"
button to select the desired level of
limescale removal: every time you press
the
the button, the corresponding indicator
light will switch on, as shown in the
table above (P1S1, P1+P2S2). For
level "S0", all the indicator lights will be
switched off.
4. Press the "START/RESET"
to save the setting and exit the settings
menu.
WARNING!
If any problem occurs, turn the
dishwasher off by pressing the "ON/OFF"
button and start the procedure
again from the beginning.
124
button for approximately
button for 5
button