Beper P206VEN101 Bedienungsanleitung Seite 10

Stand Fan Use Instructions
Description of the item
1. Outer pole
2. Base fastening screws
3. Base feet
4. Base
5. External pole blocking bolt
6. High adjustment handle
7. Base ornamental pin
8. Inner pole
9. Swing button
10. Body motor
11. Motor
12. Inclination set button
13. Night light
Instructions for use
Assembling of fan Fig.A (a-g)
Proceed as shown in pictures from a to g.
Make sure to place the base of the fan on a flat and stable surface.
Important: securely fasten the screws of the base to guarantee a good stability of the fan, and to avoid
dangerous shaking.
If the inner tube cannot be seen from the outside, it could be inserted completely inside the external tube – pro­
ceed to extract it to the desired height.
Operation Fig. B
Select the speed by pressing the relevant key on the control panel.
It is possible to adjust head tilt to regulate the direction of the air flow, by unscrewing the tilt adjustment pin as
shown in fig. B.
Warning: only proceed to adjust tilt when the fan is switched off; do not force the movement, to avoid
breakage of the tilting mechanism.
To activate swing function, press the rotating pin downwards, as shown in fig. B; pull it upwards to deactivate
swing function.
Cleaning
Before cleaning, switch off and unplug the fan.
For cleaning use a soft cloth, that may be slightly damp.
Do not use alcohol or chemical substances, or any detergent that could damage this appliance.
Do not spray water or other liquids on the fan in order to protect it.
After cleaning, dry every part before using the appliance.
During the winter and when not used, keep this appliance in a dry and clean place.
Technical data
Power : 35W
Power supply. : 220­240V~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
14. Control panel
15. Screw for pipe
16. Central disc
17. Central disc blocking screws
18. Front grid
19. Rear grid
20. Nut blades
21. Rear grid nut
22. Blades
23. Closure nut
24. Grid blocking screw
25. Grid blocking bolt
10