i-PRO WV-X86531-Z2 Installationshandbuch Seite 3

WARNING:
• Operation of this product in a residential environment could cause radio interference.
Caution:
• The DC power supply connected to the camera
must be in the same building.
• The network camera is only intended for a
connection to an ethernet or PoE network
without routing to the outside plant.
• This product has no power switch. Be sure
to install disconnect devices such as a circuit
breaker to shut down the main power of power
supplying equipment to this product.
• Before attempting to connect or operate this
product, please read these instructions carefully.
Precautions
In order to prevent harm to people and damage to property, it
explains what must be observed without fail. The safety statements
common to all i-PRO network camera models are posted on the
website linked from the twodimensional barcode on the right. Please
be sure to confirm it.
https://i-pro.com/global/en/surveillance/training-support/support/library/safety-instructions
„ Do not install this product in a restricted or prohibited environment.
Failure to observe this may result in injury, accident, or malfunction due to falling.
Please check the safety precautions common to all models on the website above and the installation
precautions in the Installation Guide.
„ Refer installation work to the dealer.
Installation work requires technique and experience. Failure to observe this may cause fire, electric
shock, injury,or damage to the product. Be sure to consult the dealer.
„ Install the product accurately and securely on an installation area in accordance with the
installation instructions.
Failure to observe this may cause injury or accidents.
„ Take measures of protection against this product falling.
Failure to observe this may cause a drop resulting in injury.
Securely fix the product to the installation surface using screws or anchors. If the fall prevention wire is
included, be sure to install it.
„ Stop the operation immediately when something is wrong with this product.
When smoke goes up from the product, the smell of smoke comes from the product, or the exterior of
the product has deteriorated, continued use will cause a fire or fall of the product resulting in injury, or
damage to property.
In this case, turn the power off immediately and contact qualified service personnel for service.
„ Conduct periodic inspections.
Rust on the metal parts or screws may cause a fall of the product resulting in injury or accidents.
Consult the dealer for the inspections.
Be sure to turn off the power before inspection or maintenance.
Notice:
• This product is not suitable for use in locations
where children are likely to be present.
• Do not install this product in locations where
ordinary persons can easily reach.
• This product is a professional equipment.
• For information about screws and other
parts required for installation, refer to the
corresponding section of this document.
: Direct current symbol
3