1.5.2 - USE OF THE HEIGHT ADJUSTABLE SPIKES - EXTRA
1. Place the speaker in its final position and place two knurled spikes and plates to the left and right of the speaker.
2. Carefully tilt the speaker to the left, turn the spikes into the thread as far as they will go, and carefully set it down again.
3. Repeat this on the right side of the speaker.
4. Now carefully tilt the speaker again and place the plate behind and in front, centered under the spike and carefully lower the speaker until it sinks cleanly into the plate or the tip of the spike is
exactly immersed in the receptacle of the plate.
5. Make sure that the speaker stands firmly in its final position and does not tilt. Compensate for this by unscrewing individual spikes.
CAUTION: Careless handling of the spikes may result in injury.