Inklang AYERS Four wireless Bedienungsanleitung Seite 22

english - EN 5
1.3 DDFA power amplifiers in overview
D
H
C
G
F
I
K
J
L
M
GENERAL
P
E
P
B
O
A
N
COMMISSIONING BURN IN
Paring. The „Pairing" key [F] is used in the „Wireless" operating mode. By briefly pressing the key in combi-
F
nation with the pairing process of the HD 10 Stream Connect, the HD 10 and speaker are connected to each
other. This is usually only necessary once. See the Quick Setup Guide of the HD 10 StreamConnect or under
2.2 Wireless mode, page 9.
Status LED display. The status LED display shows you in which operating state the amplifier is. This is done
G
by displaying different color and light signals.
Level. With the slide switch you can reduce the volume of the playback by 3 and 6 dB. This is relevant when
H
using the analog input if the signal fed in here is too loud and thus leads to distorted playback. Max. Volume
0 dB at 2V rms. Compare the max. output voltage of your analog preamplifier if necessary.
Coax Digital In. In the „Coax" [C] operating mode, the electrical digital signal is fed in via this RCA input. The
I
signal must be volume controlled.
Optical Digital In. In the „Opitcal" [C] operating mode, the optical digital signal is input via this SPDIF input.
J
The signal must be volume controlled.
Coax Digital Out. In the operating mode „Coax" [C], you can have the electrical digital signal passed on to the
K
second speaker via the digital pas thru output „Digital Out" [J].
Opitcal Digital Out. In the „Optical" [C] mode, you can use the digital pas thru output „Digital Out" [K] to pass
L
the optical digital signal to the second speaker.
Analog L + R. In the „Analog" operating mode [C], you can use an analog input signal via this input. Connect
M
the „L" input for the position selection [H] „left" for left or the „R" input for the position selection „right" for
right. For the position selection „Dual Stereo" connect the left „L" and right „R" input to combine both chan-
nels to a summed signal.
Service.
N
This USB port is exclusively for service by the manufacturer.
Fuse compartment.
O
Compartment to hold a T 6.3/250V fuse.
Ventilation openings. The various vents are used to dissipate heat from the power amplifiers. These must
P
not be closed under any circumstances. A closure leads to a safety shutdown of the amplifiers after a
very short time.
MAINTENANCE APPENDIX WARRANTY