Fitting/Changing The Saw Blade; Adjusting The Footplate; Use; Switching On And Off - Parkside Performance PSSAP 2028 A1 Originalbetriebsanleitung

Fitting/changing the saw blade

WARNING!
►
Remove the battery before carrying out
any work on the power tool (e.g. mainte-
nance, changing tools, etc.) as well as during
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury.
♦ Turn the quick-release chuck
stop and hold it in this position.
♦ Push the required saw blade
quick-release chuck
CAUTION!
► The teeth of the saw blade
downwards!
♦ Let go of the quick-release chuck
returns to its initial position. The saw blade
is now locked.

Adjusting the footplate

RISK OF INJURY!
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
♦ Adjust the footplate
depth.
♦ To do so, undo the locking lever
the footplate to the corresponding position.
♦ Lock this position by closing the locking lever
GB │ IE
■ 8 │
as far as the
into the
as far as the stop.
must point
so that it
according to the cutting
and move

Use

Switching on and off
Switching on
♦ First press the safety lock-out
ON/OFF switch
safety lock-out
Switching off
♦ Release the ON/OFF switch

Adjusting the rotational speed

Press the ON/OFF switch
speed. Increasing the pressure increases the speed.
NOTE
► The integrated motor brake ensures rapid
stoppage.

2-speed gearbox

CAUTION!
► You can only press button
2nd gear stage when the device is at a stand-
still.
♦ Press button

Guiding the sabre blade safely

To adapt to the workpiece and for safe placement,
the footplate can be swivelled. It must always be
in contact with the workpiece when the appliance
is running.

Practical advice on sawing

♦ Check the material to be worked to make sure
that all foreign objects have been removed,
e.g. nails, screws, etc.
♦ Ensure that the ventilation slits
covered.
♦ Switch the appliance on before moving it
.
towards the material to be worked.
♦ Switch the appliance off immediately if the saw
blade jams.
Open up the sawn gap using a suitable tool
and pull out the sabre saw.
and then the
. Afterwards, release the
.
.
lightly for a low
for the 1st and
to shift from 1st to 2nd gear.
are not
PSSAP 2028 A1