UNBLOCKING THE SOCKETING MACHINE WHILE
IN OPERATION
In the event of machine block (the conical
pin cannot go forward or backward), see the
following instructions:
1. Remove the tank cap as illustrated in
picture 4.
2. Loosen the vent hole cap by an hexagonal
wrench (3 mm) as illustrated in picture 5.
3. Press against the rubber tank in order to
let air go out of the vent hole. When air
is completely discharged and oil starts
coming out (picture 6) close the vent hole
cap by the hexagonal wrench.
4. Replace the tank cap. Repeat these steps,
if needed.
If the problem is not solved, send the Coupling
tool BE32 18 V to Valsir for possible verification
and repairing.
Picture 4
Picture 5
Picture 6
25