To Change The Ribbon - Sagem PHOTO EASY 155 Bedienungsanleitung

Remarque : Use DSR400 or DSR400T consumables only. These are specially designed to provide you with optimum
print rendering.
For this purpose, the printer must read the chip card delivered with each consumable kit after any new kit
installation.
Switch on the printer. Wait 10 seconds for the printhead to lift, then:
1. Take the SIM card delivered with the ribbon and the photo paper. Insert it in the drive
located on the front panel of the printer. The SIM card is identified and read by the printer.
At the end of the procedure, "40 or 120" is displayed on the screen.
2. Remove the SIM card.
3. Take the new ribbon out of its packaging and make sure that the film is stretched after
removing the card (A).
4. Open the external flap located on the right-hand side of the printer.
5. Lift the locking lever and remove the used ink ribbon.
6. Install the ribbon in the position shown in the illustration below.
7. Lift the locking lever and push in the film cartridge until it touches the back of the com-
partment the locking lever must be locked after insertion.
8. Close the external flap.
Remark: If this last operation is not carried out, you will not be able to use the printer.
7
Warning -
completely inserted into the printer. Check that the green locking lever is correctly lowered.
Remark: In the event of any difficulty, check that there are no foreign objects in the film cartridge compartment.
T
O CHANGE THE RIBBON
8
Never touch the film cartridge with your fingers. Make sure the cartridge is
- 5 -
A
6