Assembly; Operation - Husqvarna PW 240 Bedienungsanweisung

Introduction
WARNING:
safety chapter before you assemble the
product.
To install the garden hose adapter
1. Remove the transport cover from the water inlet and
discard it. (Fig. 17)
2. Install the garden hose adapter on the water inlet.
(Fig. 18)
CAUTION:
install the garden hose adapter straight
on the water inlet. If the garden hose
adapter is not installed straight, it can
cause damage to the threads and
leakage can occur.
3. Tighten the garden hose adapter fully.
4. Remove the garden hose adapter in the opposite
sequence.
Introduction
WARNING:
safety chapter before you use the product.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Follow the instruction steps in the Husqvarna
Connect app to connect and register the product.
Note:
Husqvarna Connect app is not available for
download in all markets. Speak to your servicing
dealer for more information.
1855 - 006 - 21.10.2022

Assembly

Read and understand the
Make sure that you

Operation

Read and understand the
To install the footrest and the holder for
the spray handle and the spray lance
1. Put the footrest (A) in position and install the screw
(B). (Fig. 19)
2. Put the holder (C) in position and install the 2 screws
(D).
Note:
The lower screw on the holder also holds
the footrest. Make sure that you align the hole in the
footrest with the lower screw.
To install the wheels
Note:
Before you do this procedure, make sure that
the footrest and the holder for the spray handle and
spray lance are installed. Refer to
and the holder for the spray handle and the spray lance
on page 15 .
• Put the wheel assemblies in position and install the 2
screws. (Fig. 20)
To unfold and fold the transport handle
• To unfold the transport handle, push the buttons
on the left and right side and pull up the transport
handle. (Fig. 21)
• To fold the transport handle, push the buttons on
the left and right side and push down the transport
handle. (Fig. 22)
To install the spray handle
1. Pull out the high-pressure water hose. (Fig. 23)
2. Hold the spray handle tightly with one hand and
push the high-pressure water hose into the quick
connection on the spray handle. (Fig. 24)
To remove the spray handle
1. Push the tab in the direction of the quick connection
on the spray handle and pull out the high-pressure
water hose. (Fig. 25)
2. Turn the hose reel clockwise until the high-pressure
water hose is fully wound. (Fig. 26)
To install the spray lance
1. Hold the spray handle with one hand and push the
coupling on the spray lance into the spray handle.
(Fig. 27)
2. Turn the spray lance clockwise and release the
spray lance. The spray lance locks in position.
To install the footrest
15