Maintenance; Maintenance Schedule; To Clean The Product - Husqvarna PW 240 Bedienungsanweisung

CAUTION:
agents that are recommended by
Husqvarna.
3. Push the quick connection on the foam sprayer into
the quick connection on the spray lance until it locks
in position. (Fig. 47)
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of

Maintenance schedule

Maintenance

Do a general inspection. Refer to
Clean the product. Refer to
Clean the spray lance and the nozzles. Refer to
on page 19 .
Clean the water filter. Replace the water filter if it is damaged. Refer to
filter on page 19 .
Lubricate the O-rings on the couplings. Refer to
on page 19 .
To do a general inspection
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
• Make sure that the nuts and the screws on the
product are tightened.
• Make sure that the cables on the product are not in a
position where they can be damaged.
• Examine the high-pressure hose for wear and
damage.
18
Use only cleaning
Maintenance
Before you do
To do a general inspection on page 18 .
To clean the product on page 18 .
To clean the spray lance and the nozzles
To lubricate the O-rings on the couplings
Put the power switch in the
Disconnect the product from
Note:
The flange on the foam sprayer must align
with the groove in the spray lance.
4. Connect the product to a water source. Refer to
connect the product to a water source on page 16 .
5. Start the product. Refer to
page 17 .
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarna.com.
To clean the water
WARNING:
product if the high-pressure hose is worn
or damaged.

To clean the product

WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
• Clean all external parts with a dry cloth.
• Do not use a high-pressure washer to clean the
product.
• Keep the air inlets clean to make sure that the
product always has sufficiently cool temperature.
To start the product on
Before use After use
X
X
X
X
X
Do not operate the
Put the power switch in the
Disconnect the product from
1855 - 006 - 21.10.2022
To