Husqvarna PW 240 Bedienungsanweisung Seite 19

To clean the spray lance and the nozzles
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
1. If a nozzle is installed on the spray lance, remove it
from the spray lance. Refer to
a nozzle on page 16 .
2. Clean the nozzles, the coupling on the spray lance,
and the coupling on the spray handle with soap and
water. (Fig. 48)
3. If there is blockage in the nozzles, remove it with the
cleaning tool. (Fig. 49)
To clean the water filter
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
1. If the garden hose adapter is installed, remove it
from the water inlet on the product. (Fig. 38)
2. Pull out the water filter. Use a pair of pliers. (Fig. 50)
3. Do a check for damage on the water filter. Replace
the water filter if it is damaged. (Fig. 51)
4. Flush the water filter with clean water. (Fig. 52)
To lubricate the O-rings on the
couplings
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
1855 - 006 - 21.10.2022
Put the power switch in the
Disconnect the product from
To install and remove
Put the power switch in the
Disconnect the product from
Put the power switch in the
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
1. Remove the spray lance from the spray handle and
the spray handle from the high-pressure hose. Refer
To install the spray lance on page 15 and To
to
install the spray handle on page 15 .
2. Lubricate the O-rings on the garden hose adapter,
the spray lance, and the high-pressure hose with
Technical data on page 21 for the
grease. Refer to
correct type of grease. (Fig. 53)
To remove and install the hose reel
cover
WARNING:
off (0) position and disconnect the power
plug from the power source before you do
maintenance on the product.
CAUTION:
the water source and make sure that all
parts are dry before you do maintenance on
the product.
The hose reel cover is attached with 3 snap locks.
1. Push in the 3 snap locks and carefully remove the
hose reel cover. (Fig. 54)
2. To install the hose reel cover, carefully push it until
the snap locks locks it in position.
Disconnect the product from
Put the power switch in the
Disconnect the product from
19