Assembly; Operation - Husqvarna PW 130 Bedienungsanweisung

Introduction
WARNING:
safety chapter before you assemble the
product.
To install the garden hose adapter
1. Remove the transport cover from the water inlet and
discard it. (Fig. 17)
2. Install the garden hose adapter on the water inlet.
(Fig. 18)
CAUTION:
install the garden hose adapter straight
Introduction
WARNING:
safety chapter before you use the product.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Follow the instruction steps in the Husqvarna
Connect app to connect and register the product.
Note:
Husqvarna Connect app is not available for
download in all markets. Speak to your servicing
dealer for more information.
To install the spray handle
1. Push the high-pressure water hose into the quick
connection until it locks in position. (Fig. 20)
CAUTION:
make sure that the high-pressure hose
1839 - 006 - 21.10.2022

Assembly

Read and understand the
Make sure that you

Operation

Read and understand the
To prevent leakage,
on the water inlet. If the garden hose
adapter is not installed straight, it can
cause damage to the threads and
leakage can occur.
3. Tighten the garden hose adapter fully.
4. Remove the garden hose adapter in the opposite
sequence.
To install the holder for the spray
handle and the spray lance
• Install the holder with the 2 screws. (Fig. 19)
is fully connected to the quick connection
on the product.
2. Hold the spray handle tightly with one hand and
push the high-pressure water hose into the quick
connection on the spray handle. (Fig. 21)
To remove the spray handle
1. Push the button on the spray handle and pull out the
high-pressure water hose. (Fig. 22)
2. Push the outer ring on quick connection and pull out
the high-pressure water hose. (Fig. 23)
To install the spray lance
1. Hold the spray handle with one hand and push the
coupling on the spray lance into the spray handle.
(Fig. 24)
2. Turn the spray lance clockwise and release the
spray lance. The spray lance locks in position.
To remove the spray lance
1. Push in the spray lance and turn it counterclockwise.
(Fig. 25)
2. Pull out the spray lance from the spray handle.
To install and remove a nozzle
The product is supplied with 2 nozzles: 1 nozzle with
a straight water jet (identified with "gentle nozzle") and
1 rough nozzle with a rotating water jet (identified with
"rough nozzle". The nozzle with a straight water jet
can be used to clean sensitive surfaces, for example
vehicles. The nozzle can be used to clean surfaces that
are not sensitive, for example driveways.
(Fig. 26)
15