Declaration Of Conformity (Doc); Technical Data - Sygonix 2612693 Bedienungsanleitung

a
The receiver is paired with fewer than 8 transmitters.
1. On the receiver, press and hold the mode button for approximately 3 seconds until a tone
sounds.
à
The receiver will be open for pairing for 30 seconds.
2. On the transmitter, press the button 2x.
à
Repeat the above steps if pairing is not successful.
3. Pairing is successful if the doorbell (doorbells) chime.
8.2 Delete pairing
Perform a reset if you want to clear all pairing codes from a receiver.
Preconditions:
a
The receiver is connected to the power supply.
1. On the receiver, press and hold the mode button for approximately 10 seconds.
2. 2x tones will sound to indicate all pairing codes have been deleted.
à
The receiver can now be paired with up to 8x transmitters.
8.3 Functions
Button Name Function
Mode Press to cycle through modes:
Ring and flash, ring only, flash only, ring with constant light.
Volume Press to cycle through volume levels.
Tones Press to cycle through tones.
9 Cleaning
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Disconnect the chime box from the power supply.
2. Clean the product with a dry, fibre-free cloth.

10 Declaration of Conformity (DOC)

Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau hereby declares that this
product conforms to the 2014/53/EU directive.
■
Click on the following link to read the full text of the EU declaration of conformity:
www.conrad.com/downloads
Enter the product item number in the search box. You can then download the EU declaration
of conformity in the available languages.
11 Disposal
11.1 Product
This symbol must appear on any electrical and electronic equipment placed on
the EU market. This symbol indicates that this device should not be disposed of
as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-
back of waste. Conrad provides the following return options free of charge (more details on
our website):
■
in our Conrad offices
■
at the Conrad collection points
■
at the collection points of public waste management authorities or the collection points
set up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply
in countries outside of Germany.
11.2 (Rechargeable) batteries
Remove batteries/rechargeable batteries, if any, and dispose of them separately from the
product. According to the Battery Directive, end users are legally obliged to return all spent
batteries/rechargeable batteries; they must not be disposed of in the normal household
waste.
Batteries/rechargeable batteries containing hazardous substances are labelled
with this symbol to indicate that disposal in household waste is forbidden. The
abbreviations for heavy metals in batteries are: Cd = Cadmium, Hg = Mercury,
Pb = Lead (name on (rechargeable) batteries, e.g. below the trash icon on the
left).
4
Used (rechargeable) batteries can be returned to collection points in your municipality, our
stores or wherever (rechargeable) batteries are sold. You thus fulfil your statutory obligations
and contribute to environmental protection.
Batteries/rechargeable batteries that are disposed of should be protected against short cir-
cuit and their exposed terminals should be covered completely with insulating tape before
disposal. Even empty batteries/rechargeable batteries can contain residual energy that may
cause them to swell, burst, catch fire or explode in the event of a short circuit.

12 Technical data

12.1 Receiver
Input ............................................... 100 – 240 V/AC, 50/60 Hz, 0.5 W Max.
Protection class .............................. II
Memory........................................... max. 8 transmitters
Melodies ......................................... 58
Volume levels ................................. 4
Modes............................................. ring and flash, ring only, flash only, ring with constant
Doorbell volume.............................. max. 85 dB
Operating / Storage conditions....... -20 to +60 °C ≤85 % RH
Dimensions (L x W x D).................. 90 x 60 x 69 mm
Weight ............................................ 68 g
12.2 Transmitter
Power supply.................................. 1x 3 V/DC CR2032 battery
Ingress protection........................... IP44
Transmission frequency range ....... 433.845 - 433.995 MHz
Transmission power ....................... <10 dBm
Transmission distance.................... ≤180 m (open area)
Operating / Storage temperature.... -20 to +60 °C
Dimensions (L x W x H).................. 31 x 72 x 21 mm
Weight ............................................ 28 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2612693_V1_0822_dh_mh_en 632545035-2 I1/O1 en
light