Troubleshooting - PEAKnx Controlmicro Kurzanleitung

3 Audioassistant of the TKS Communicator
5. Optimize microphone volume
− Move the slider to the second line from the right.
6. Test configuration
− Start the configuration test.
7. Finish Audio Assistant
− Close the audio assistant and have fun with your Controlmicro intercom!

3.1 Troubleshooting

Problem
After a few seconds of good intelligibility
on the door unit, the person on the PEAKnx
Panel is suddenly perceived quiet and barely
audible or cut off and hard to hear.
At the door unit, the person at the PEAKnx
Panel is perceived at the correct volume but
with white noise in the background.
At the door unit, the person at the PEAKnx
Panel is perceived too quiet.
Solution
Microphone is amplified too much, see
point 4 Microphone volume. Reduce micro-
phone volume slightly or reduce microphone
level slightly (slider to the left)
The wizard amplifies the microphone of
the PEAKnx Panel too much, see point 5
Optimize microphone volume. Reduce the
microphone volume (slider to the left)
The microphone is not amplified enough,
see point 4 Microphone volume. Increase the
microphone volume (slider to the right)
30