Resetting To The Initial State - HomeMatic HM-LC-Dim1T-CV Installations- Und Bedienungsanleitung

Button
Brief button press
"ON" button
Brief button press
"OFF" button
Long button press
"ON" button
Long button press
"OFF" button
9

Resetting to the initial state

In order to reset the actuator to factory status, switch
the device to teach mode with the channel button (hold
button pressed for at least 4 seconds). If the device is
in teach mode, press the channel button again for at
least 4 seconds. The actuator reset is indicated by the
device LED flashing quickly.
32
Behavior
ON
OFF
Brighter
Darker