Symbols Used In This Manual; Symbols On The Power Tool; For Your Safety; Intended Use - Flex CS 45 18.0-EC Originalbetriebsanleitung

Symbols used in this manual

WARNING!
Denotes impending danger. Non- observance
of this warning may result in death or
extremely severe injuries.
CAU TION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in
slight injury or damage to property.
N OTE
Denotes application tips and important
information.

Symbols on the power tool

To reduce the risk of injury, read the
operating instructions!
Wear goggles!
Wear ear protection!
Wear mask!
Disposal information for the old
machine

For your safety

WARNING!
Before using the power tool, please read and
follow:
these operating instructions,
the "General safety instructions" on the
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged.
14
The circular saw may be used only
as intended,
in perfect working order.
Faults which impair safety must be repaired
immediately.

Intended use

The circular saw is designed
– for commercial use in industry and trade,
– for cutting wood lengthways and crossways
in straight lines.
Safety warnings for circular saw
Cutting procedures
a) Do not reach underneath the workpiece.
The guard cannot protect you from the
blade below the workpiece.
b) Adjust the cutting depth to the thickness
of the workpiece. Less than a full tooth
of the blade teeth should be visible below
the workpiece.
c) Never hold the workpiece in your hands
or across your leg while cutting. Secure
the workpiece to a stable platform. It is
important to support the work properly to
minimize body exposure, blade binding, or
loss of control.
d) Hold the power tool by insulated
gripping surfaces, when performing
an operation where the cutting tool
may contact hidden wiring or its own
cord. Contact with a "live" wire will also
make exposed metal parts of the power
tool "live" and could give the operator an
electric shock.
e) When ripping, always use a rip fence or
straight edge guide. This improves the
accuracy of cut and reduces the chance of
blade binding.
f) Always use blades with correct size and
shape (diamond versus round) of arbour
holes. Blades that do not match the
mounting hardware of the saw will run off-
centre, causing loss of control.
g) Never use damaged or incorrect blade
washers or bolt. The blade washers and
bolt were specially designed for your saw,
for optimum performance and safety of
operation.
CS 45 18.0-EC