Disposal / Recycling - Eaton Serie: eLL. 92 LED 400 Betriebsanleitung

7 Repair / Overhaul / Modifications
Repairs and overhaul may only be carried out
with genuine Eaton's Crouse-Hinds Business /
CEAG spare parts.
In the event of damage, replacement of
these components is mandatory. In case of
doubt, the respective apparatus shall be sent
to Eaton's Crouse-Hinds Business / CEAG for
repair.
Reconstruction or modifications to LED module
are not permitted.
Repairs that affect the explosion protec-
tion, may only be carried out by Eaton's
Crouse-Hinds Business or a qualified
electrician in compliance with the applicable
national rules (IEC/EN 60079-19).
Modifications to the device or changes of its
design are not permitted.
7.1 LED-module replacement
LED-module replacement can be done without
cut off the luminaire from mains supply,
because an all pole switch will isolate the
lampholders while opening the protective bowl.
Notice: Observe national standards or
directions for use which can be divergent to
this!
The LED-module have to be replaced as
shown in Fig. 2.12 and 2.13.
Explosion protected light fittings
Series: eLL. 92 LED 400 and eLL. 92 LED 800
8.

Disposal / Recycling

When the apparatus is disposed of, the
respective national regulations on waste
disposal will have to be observed.
Subject to modifications or supplement of
the product range
In order to facilitate the recycling of individual
components, plastic parts are provided with
the identification mark of the plastic material
used.
9. Rebuilding of the light fitting at
Fluorescent lamps inserting
If the light fitting eLL. 92 operating with
Fluorescent lamps, consider of the following
items:
1. Open the light fitting eLL.92 as shown in
operating instruction.
2. Replace LED-module (Fig 2.12 and
Fig 2.13).
EATON's Crouse-Hinds Business
9.1 Fluorescent lamps inserting
Observe the safety instructions of the
lamp manufacturer!
Only use such Fluorescent lamps that
have been certified for these light fittings:
T8 Bi-pin-lamps 18 W and 36 W acc.
IEC 60081 with G13-holders.
The Fluorescent lamps is to be inserted to its
stop into both holders, see fig. 2.14, so that
both pins on either side of the Fluorescent
lamps engage in the holder.
Then turn the Fluorescent lamps through 90° to
its lock-in position, see fig. 2.15, the green
surface in the holder getting visible. Now the
Fluorescent lamps is secured against falling
out.
9.2 Fluorescent lamps inserting
replacement
– Keep replacement intervals as specified by
the Fluorescent lamps manufacturer!
– Fluorescent lamps replacement can be done
without cut off the luminaire from mains
supply, because an all pole switch will isolate
the lampholders while opening the protective
bowl.
Notice: Observe national standards or
directions for use which can be divergent to
this!
E
11