Inhaltsverzeichnis
Werbung
PRODUCT CHARACTERISTICS
The straight grinder is a type of grinder which allows the material to be machined with grinder pins, wire brushes, and polishing
wheels. Due to the small size of the accessories, it is particularly suitable for work in places that cannot be reached with other
types of grinders. The correct, reliable, and safe operation of the tool depends on its proper use, therefore:
Read this entire manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this manual.
ACCESSORIES
The tool is supplied complete and does not require assembly. Wrenches for assembling and disassembling accessories are sup-
plied with the product. The equipment does not include machining accessories such as grinding wheels.
TECHNICAL DATA
Parameter
Catalogue No.
Power supply voltage
Power frequency
Rated power
Insulation class
Rated speed
Tool chuck diameter
Max. grinding tool diameter
Weight
Noise level
- sound pressure L
± K
pA
pA
- sound power L
± K
wA
wA
Vibration Level a
± K
h
Protection rating
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters what-
soever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and
moving elements. Damage to the power supply cable increases the risk of an electric shock.
In case work is realised outside closed areas, it is necessary to use extension cords designed for applications outside
closed areas. Using a correct extension cord permits to reduce the risk of an electric shock.
O R I G I N A L
10
GB
Unit
[V~]
[Hz]
[W]
[min
]
-1
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s
2
]
I N S T R U C T I O N S
Value
YT-82080
230 - 240
50
750
II
10000 - 30000
6
50
1.8
75.0 ± 3.0
85.0 ± 3.0
2.5 ± 1.5
IP20
Werbung
Inhaltsverzeichnis
