Connecting External Devices; Connecting A Set Of Headphones; Power Supply Connection - AudioAffairs NRD 010 Bedienungsanleitung

Connecting external devices

7. CONNECTING EXTERNAL DEVICES
To connect external devices, you require an audio cable (not included in the scope of
supply). The cable must have a 3.5 mm jack plug for the socket AUX IN. The type of
plug on the other end depends on the audio output port of the external device.
• Press the SOURCE button repeatedly until AUX-Eingang (AUX-In) appears on the
display.
WARNING!
• Turn down the volume on the devices before you connect them to one another.
• Switch off all devices before you connect them to one another, and comply with
the instructions for the devices that you wish to connect.

8. CONNECTING A SET OF HEADPHONES

WARNING! To prevent a potential hearing loss, please avoid listening at high
volumes for extended periods.
1. Use – VOLUME + to set the lowest volume.
2. Insert the jack plug of the headphones or earphones in the headphones socket
on the rear of the device. The sound is now played back only through the
headphones.
3. Adjust the volume with – VOLUME +.

9. POWER SUPPLY CONNECTION

• Insert the mains plug into a readily accessible power socket whose voltage
matches the voltage stated on the rating plate. The power socket must still be
easily accessible after connection.
NOTE: to disconnect the device from the mains pull out the mains plug out of the pow-
er socket.
40
www.gt-support.de
Nostalgia Radio
CUSTOMER SERVICE
00800 - 45622000