Chris Benz Depthmeter Digital Bedienungsanleitung Seite 37

11. DIVING MODE
DEPTH
DIV DIV
0 0 . 0 m 0 0 . 0 m
0.0 m
DIV
0 0 . 0 m
1.0 m
DIV
1 . 0 m
DIV
1 8 . 6 m
25.0 m
DIV
2 5 . 6 m
80.0 m
DIV
8 0 . 0 m
DIV
- - . - -
70
DEPTH MEASUREMENT
The diving depth is measuremed every second
and is displayed on the watch.
Units of depth measurement: 0.1m (1ft)
Range of measurement: 1.0m (4ft) bis 80.0m (260ft)
When diving depth is less than 1 meter the
display will be shown 00.0m (00.0ft).
When diving depth exceeds 80 meter (260ft)
the display will be shown --.--m (---ft).
ATTENTION: In case of „ER" (Error) displayed
depth reading fl ashes the depth measurement
is faulty.
11. DIVING MODE
DEPTH
0 0 0 0
0.0 m
2 8 3 5
Within
Stop 10 minutes
Start Start
0 0 0 1 2 8 3 6
1.0 m
2 0 1 7 1 2 .7 C
ATTENTION: While button (A) stays
depressed during the display of the diving
time, the display shows water temperature
readings, not the diving time.
DIVE TIME MEASUREMENT
When the diving depth reaches to 1.0 meter
(4ft), the dive time measurement will start. It
stops when the depth becomes less than 1.0
meter (4ft). If the diving depth becomes deeper
than 1.0 meter (4ft) within 10 minutes after the
end of the dive time, the dive time resumes at
the time when the measurement is stopped and
the accumulative time is recorded successively.
WATER TEMPERATURE MEASUREMENT
Water temperature measurement starts 1
minute after a depth of 1.0 m (4ft) is measured
and displayed. Subsequently, temperatures will
be measured every minute.
Units of temperature measurement: 0.1°C (1°F)
Range of measurement: -10°C bis +40°C
71