Chris Benz Depthmeter Digital Bedienungsanleitung Seite 35

10. DIVE ALARM MODE
Digital display (I)
Depth
alarm
(B) (A)
3 0 m
2 0
(M)
Digital display (II)
Dive time
alarm
66
SETTING THE DEPTH ALARM / DIVE TIME ALARM
Press button (B) for 2 seconds or longer to
switch to dive alarm correcting mode (the
preset depth value starts fl ashing). At this time,
the digital display (II) changes from the dive
time alarm display to the display for the number
of times the alarm will be activated.
Set a diving depth at which you want the alarm
to sound by pressing button (A). Each time but-
ton (A) is pressed, the depth setting becomes
deeper by 1 meter (4ft). A mximum setting is 80
meters (260ft). With the maximum exceeded,
the setting is returned to 1 meter (4ft).
ATTENTION: Rapid advance of settings is made
by pressing and holding down button (A).
10. DIVE ALARM MODE
Press button (B) to switch to the number of times of alarm occurrences correcting mode
(the preset number of times starts fl ashing).
Change and set the numbers of times of alarm occurrences by pressing button (A). The display
for the alarm frequency is changed and cycled in the following order ON - OFF - 1 - 2 - 3 - 4 - 5.
ON: The depth alarm will beep every minute when the diving depth is deeper than the set depth.
OFF: The depth alarm is disabled.
Press button (B) to switch the dive time alarm display to the correcting mode
(the preset value for the dive time alarm starts fl ashing).
Change and set the dive time alarm time by pressing button
alarm is changed and cycled in the following order -- - 05 - 10 - 15 - 20 - 25 - ... - 95 - --.
Press button (B) or (M) to fi nish the setting procedure.
ATTENTION: The alarms may be hard to hear depending on the surroundings (such as the
sound of air bubbles) and the watch wearing conditions, so take care in using the alarm.
(A). The display for dive time
67