Installation And Connection - EUROM Mini Fireplace heater Bedienungsanleitung

22. Keep the fireplace clean. Dust, dirt and/or deposits in the fireplace often lead to
overheating. Ensure that this type of build-up is regularly removed. Do not use
aggressive products or metal scourers for cleaning the device as this will damage
the housing and parts of the metal may find their way into the electrical parts
and lead to short circuiting.
23. Never switch the device on if you have noticed damage to the device itself, the
cable or plug or if it does not work properly, has fallen or shows any other signs
of failure. Take the entire device back to your supplier or a recognised electrician
to be checked and/or repaired. Always ask for original parts to be used.
24. Do not use accessories that have not been supplied or approved by the
manufacturer.
25. The bulb is the only part of this device that the user may replace themselves.
Any other repairs to the fireplace, cable or plug must always be carried out by
qualified personnel. Repairs that have not been carried out correctly may pose a
risk!
26. Only use the fireplace for its intended purpose and as stipulated in this
instruction booklet.
Failing to adhere to instructions 24, 25 and 26 could lead to damage, fire and/or
personal injury. This will invalidate the guarantee and the supplier, importer and/or
manufacturer will take no responsibility for the consequences!
DESCRIPTION
The MINI FIREPLACE HEATER is a nostalgic fire with an internal heating element and
a ventilator. The ventilator sucks air at the backside and blows warm air from the
front. So keep sufficient free space around the heater: both at the front side > 1
meter and at the rear > 0,5 meter!
The fire comes with an instruction booklet that must also be supplied on resale.

INSTALLATION AND CONNECTION


Remove the packaging materials and keep out of the reach of children. After
removing packaging, check device for damage or any evidence that may point to
a defect/failure. If in doubt, do not use the device but refer to your supplier for
checks/repairs.

Place the heater on a sturdy, flat surface. The aspiration grilles are located at the
back side; make sure they are never blocked! Do not place the fire on high-pile
carpets and never on soft surfaces like mattresses, cushions or blankets.

Choose a suitable location for the fireplace, at least one metre from all
obstructions, walls and flammable materials (see safety instructions) and in the
vicinity of a 16 Amp (at least) fused, earthed electrical socket (protected by a 30
mA earth leakage circuit breaker).
10