• Insert the rainfall sensor into its holder. It will hold
the count rocker firmly automatically.
F
Only one orientation is correct; the cable
of the rainfall sensor and the magnet of the
count rocker have to be on the same side;
the plastic nib on the other side has to be
inserted precisely into the holder, look at
the circle in the picture on the right.
• Place the cone collector from the top onto the sensor carrier and snap it in by turning it to the
left.
• Push the lower part of the rain gauge housing upwards and lock it by turning it to the right
until it snaps in.
F
The drain holes in the lower part of the housing have to point to the outside so that
the water does not run on to the metal stands.
55