Inhaltsverzeichnis
Werbung
4. Press
/
Auto
Heat
Dry
/ Cool
• Temperature settings cannot be made in Fan mode.
• The temperature range that can be set varies depending on the model.
• The maximum temperature varies depending on the system and operating
condition.
to select the flap direction.
5. Press
• Every time you press
(Swing) →
• If you press
swinging and set it in place as desired.
• When the unit is in heating standby, the flap (up-down wind direction plate) faces
upwards.
• The available functions differ depending on the indoor unit being used.
• "
" is displayed if the function is not available.
• Never try to manually move the flap (up-down wind direction plate) that is
operated by the remote controller.
Stop: Press
• If you cannot turn the air conditioner off in the normal way, disconnect the power
to the indoor unit and contact the dealer where the product was purchased.
• When the unit is stopped with the remote controller, the fan on the outdoor unit
may continue to run for a while.
< Auto operation >
It heats or cools automatically via the differences between the set temperature
and the room temperature.
Auto operation is available only when identical refrigerant system inside all the
indoor units or cooling/heating free-type are under control as 1 group. When
using gas heat pump (GHP) air conditioners, contact the dealer where the
product was purchased.
to set the temperature.
MAX (°C) MIN (°C)
27
17
30
16
30
18
, it cycles from "
(Stop)".
again while the flap is swinging, you can stop the flap from
.
→
→
→
→
→
9
Werbung
Inhaltsverzeichnis
