9. Insert the antenna tubes
Important:
Prevent damage! Always remove the antenna tubes before placing the boat in the carry bag.
Feed each antenna through the tubes then insert them into the antenna tube slot. See "a) Boat" on page 34.
10. Insert batteries
a) Transmitter
1. Open the battery compartment cover.
2. Insert batteries matching the polarity shown inside the compartment.
3. Close the compartment cover.
b) Boat
Important:
• The battery must not get wet.
• Wipe away any moisture from around the battery compartment before opening it.
• Disconnect and remove the battery when the boat is not in use.
• Make sure the compartment cover is properly closed before operating the boat.
Remove the battery compartment cover.
36
v
• Secure the battery using the hook and loop strap.
• Connect the plug.