Modes Of Operation; Display Description; Button Functions - Beta 680 Bedienungsanleitung

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
5. Remove the torque screwdriver/wrench and clear the display (if need be) by pressing the
RESET button
6. Repeat measurement operation 4.

MODES OF OPERATION

Display description

1) Selected mode
2) Set target value
3) Measured value
4) Selected unit of measurement
5) Applied torque indicator

Button functions

Units button
- Press to change the unit of measurement
- Hold the button to enter UNITS MENU:
- to select the unit of measurement, press
- To enable (√)/ disable (x) a unit of measurement, press
- To exit and save the input settings:
- select and press
- To go back to the measurement screen without saving the input settings, press
Mode Button
- Press to select one of the following modes:
• Click, to measure the first torque value. The display will be automatically cleared after 3 seconds.
• Track, to instantly read the applied torque.
• Dial, to measure the highest torque peak. To clear the display, press
Hold to enter CLICK MENU:
14
to confirm
EN I