If You Want To Load More Dishes; Power Failure; Once The Program Has Finished; The Best Drying Results - Atag VA2214MP Gebrauchsanweisung

Using the dishwasher

If you want to load more dishes

Open the door. The dishwasher stops automatically. Add the dishes and close the door. After a
while, the dishwasher continues the program.

Power failure

If the dishwasher is turned off due to a power failure when a dishwashing program is running, the
program continues when power is restored. If the power is cut during drying, the program is
interrupted.
If the door is open for more than 2 minutes during drying, the program is interrupted.

Once the program has finished

The end of the program is indicated by one short signal from the buzzer. The chapter Settings
describes how to change this function.
Moreover, the end of the program is indicated by the status light turning off.
Once the dishwasher door is opened and the program has finished "End" appears on the display.
The dishwasher switches off automatically after the program ends. Shut off the water tap after each
use.

The best drying results

Fully load the dishwasher.
Angle dishes with hollows, such as cups, so that the rinse water will run off. This is also important
for plastic items.
Top up with rinse aid or increase the rinse aid dosage setting.
Activate the
Allow the dishes to cool before unloading the dishwasher.

Unloading the dishwasher

Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher before unloading them.
Unload the lower basket first to avoid any water drops from the upper basket falling onto the dishes
in the lower basket.
1)
You should not load more dishes if the lid of the detergent dispenser has been opened.
18
Automatic door opening option.
1)