Atag VA2214MP Gebrauchsanweisung Seite 154

Problem
Water remains in the
dishwasher.
Bad odour in dishwasher.
Grease deposits in the
dishwasher.
The dishes are not dry enough.
Possible causes
The filters are clogged.
The filters are not fitted correctly.
Debris in the drainage pump.
Drainage pump stop missing.
Kink in drainage hose.
Blocked drainage hose.
Dirt around the seals and in
corners.
Low temperature programs have
been selected for a prolonged
period.
Low temperature programs have
been selected for a prolonged
period.
The Automatic door opening
option is not activated.
The dishwasher is not fully
loaded.
Rinse aid needs topping up or
dosage is set too low.
The setting TAB is activated and
all-in-one detergent with
insufficient drying effect is being
used.
Troubleshooting
Action
Clean the coarse and fine filters.
Check that the filters are fitted
correctly. See the chapter Care
and cleaning.
Clean the drainage pump. See
the chapter Care and cleaning.
Check that the yellow drainage
pump stop (on the right in the
bottom drain) is in place. See
the chapter Care and cleaning.
Check that the hose is free from
kinks and sharp bends.
Disconnect the drainage hose
where it connects to the sink
unit's water trap. Check that no
debris has fastened and that the
connection has an inner
diameter of at least 14 mm.
Clean with washing-up brush
and low foaming cleaner.
Run a program with a high
temperature once or twice a
month. Or run a self-cleaning
program. See Self-clean in the
chapter Using the dishwasher.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as
Intensive 70°. Or run a
self-cleaning program. See
Self-clean in the chapter Using
the dishwasher.
Activate the Automatic door
opening option.
Fully load the dishwasher.
Top up with rinse aid or increase
the rinse aid dosage setting.
Switch all-in-one detergents or
deactivate the TAB setting and
top up with salt and separate
rinse aid. See Rinse aid in the
chapter Settings.
31