Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions; Installation - AEG BPE548070B Benutzerinformation

Vorschau ausblenden Andere Handbücher für BPE548070B:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

If the mains power supply cable is damaged, it must be
replaced by the manufacturer, its Authorised Service Centre
or similarly qualified persons to avoid an electrical hazard.
WARNING: Ensure that the appliance is switched off before
replacing the lamp to avoid the possibility of electric shock.
WARNING: The appliance and its accessible parts become
hot during use. Care should be taken to avoid touching
heating elements.
Always use oven gloves to remove or put in accessories or
ovenware.
Use only the food sensor (core temperature sensor)
recommended for this appliance.
To remove the shelf supports first pull the front of the shelf
support and then the rear end away from the side walls.
Install the shelf supports in the opposite sequence.
Do not use a steam cleaner to clean the appliance.
Do not use harsh abrasive cleaners or sharp metal scrapers
to clean the glass door since they can scratch the surface,
which may result in shattering of the glass.
Excessive spillage must be removed before the pyrolytic
cleaning. Remove all parts from the oven.

2. SAFETY INSTRUCTIONS

2.1 Installation

WARNING!
Only a qualified person must install this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Follow the installation instructions supplied with the appliance.
• Always take care when moving the appliance as it is heavy. Always use safety gloves and
enclosed footwear.
• Do not pull the appliance by the handle.
• Install the appliance in a safe and suitable place that meets installation requirements.
• Keep the minimum distance from other appliances and units.
• Before mounting the appliance, check if the oven door opens without restraint.
• The appliance is equipped with an electric cooling system. It must be operated with the
electric power supply.
• The built-in unit must meet the stability requirements of DIN 68930.
SAFETY INSTRUCTIONS
5/160

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis