Use - MAXXMEE SS02 Gebrauchsanleitung

EN
■
Babies and sleeping or unconscious
people must not be placed on the
device.
■
Only use the device if you have no
physical illnesses or ailments! If you
are unsure whether the device may be
used, consult a doctor.
■
People with a pacemaker may use the
device only after consultation with
their doctor.
■
Pregnant women or those who have
recently given birth should not use
the device, or should use it only after
consultation with their doctor.
■
Do not use the device on injuries,
swelling, skin irritations, infected skin,
warts, fungal infections, abnormal
changes in the skin or body parts with
no feeling.
■
Switch off the device immediately if
you experience pain or feel unwell
during use.
NOTICE – Risk of Damage to Materi-
al and Property
■
Disconnect the device from the mains
power if a fault occurs or in a thunder-
storm.
■
When you disconnect the device
from the mains power, always pull on
the mains plug and never the mains
cable.
■
Never pull or carry the device by the
mains cable.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
■
Use and store the device at room
temperature, do not expose it to
extreme temperatures or temperature
fl uctuations. Protect the control unit
from any impacts.
■
Do not use the connecting cable or
control unit with another device.
12

USE

Please Note!
■
Only connect the device to a plug
socket that is properly installed. The
plug socket must also be readily
accessible after connection so that the
connection to the mains can quickly
be isolated. The mains voltage must
match the rating plate of the control
unit.
■
Make sure that the connecting cable
does not present a trip hazard.
■
Make sure that the connecting cable
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces.
■
Do not place the connecting cable
or the control unit on or beneath the
heating pad during operation.
1. Plug the connecting cable into the
socket (2) on the heating pad (3).
2. Connect the mains plug to a plug
socket.
3. Turn the heating pad either into a foot
warmer or a hand warmer by closing
the buttons (Picture B and C). Or place
it on your back, stomach or legs with
the buttons open (Picture D and E).
4. To switch on the device, slide the
slide control (6) on the control unit (1)
to the heat level you want. The
display (7) lights up and shows the
chosen heat level.
 
The device switches off automati-
cally after 90 minutes.
5. To switch off the device, slide the
slide control to the 0 position. The
display switches off.
 
If the heating pad is used in bed,
we recommend switching it off
before you go to sleep.