Operation - Lacor INSTANT Gebrauchs- Und Instandhaltungsanleitung

1
5
You should follow the instructions in the maintenance section of this manual before using the
dispenser for the first time.
1.- Clean the tray (5) and the water tank (7) with soap and water every day.
2.- Fill the tank with cold water. Dump out any water that was previously in the tank.
The water level must be between the minimum and maximum lines (PHOTO 1) for the boiler
to work properly.
NOTE:
This item can only be used with water. Do not fill the tank with any liquid that is not
water. Use decalcified water to lengthen the device's life.
3.- Put the tray below the spout. The tray has a magnetic base. Bring the tray close to the
dispenser so the magnets in the tray and the ones in the body attract each other and the
tray gets pulled into position (PHOTO 2).
4.- Plug the dispenser into a compatible electrical outlet and push the LOCK (h) button to
programme the machine.
NOTE:
Even though the dispenser is connected to the electrical network, the display will
turn off if it is not running. Push any button to turn on the display and continue programming
it.
5.- Follow the instructions below to calibrate the machine before using it for the first time or after
moving it.
a) Select 25º C using the TEMPERATURE (g) button.
b) Select the longest measurement (300 ml) using the pour VOLUME (i) button.
c) Put a cup or glass underneath the spout and push the DISPENSE (f) button to start
the dispensing cycle.
d) After the cycle finishes, empty the water container and put it back under the spout.
e) Do another dispensing cycle. Select 95º C and the longest dispensing measurement
(300 ml). The boiler is configured in this way.
40

OPERATION

2 3
6
4