Set-Up And Connection Guide; Water Inlet; Water Outlet - Daan Tech Bob Schnellstartanleitung

2 | S -
ET UP AND

2.1 | Water inlet

1
Plug the water inlet hose
to the back of Bob on one end and to a water
inlet on the other via the 19 mm threaded end
(3/4 inch) and ensure it is a tightly attatched
and secured.
WARNING: Close the water supply tap
after each use.
Warning: Do not block the inlet for the
water tank. This must always remain
unblocked.

2.2 | Water outlet

Connect the water drain hose to the back of Bob.
Warning: To prevent leaks, use a screwdriver to attach the
water outlet.
C
ONNECTION
2 options
Using Bob as an autonomous free-standing
dishwasher with its built-in water tank. In this
case, no water inlet hose is needed! Use the
Bob Carafe to fi ll the water tank with water not
exceeding 140°F.
Before each use, fi ll the water tank with the door
open, until you hear the sound signaling that the
tank is full.
G
UIDE
2
Do not overfi ll the tank! If you overfi ll
the water tank (1gal/ 4L), the excess water
will spill into Bob's interior.
3