Adding Extra Items During An Ongoing Cycle; Drying In Progress; At The End Of The Wash Cycle; Standard Programs - Daan Tech Bob Schnellstartanleitung

Adding extra items during an ongoing cycle

Press the central button
Open the door and be careful of potential hot steam escaping
Place the additional item in the basket
Close the door
Select to continue the cycle
Warning: If you want to cancel a cycle or add additional items, you must press the central
button to interrupt the program.
cycle end
When the timer is close to zero, the "Drying in progress" screen is displayed.
Please note that some water
residue may remain on your
dishes if you do not wait for
When the program is completed, a signal sound occurs (unless you have turned off the sound in
"Settings") and Bob will automatically go into standby mode.
Upon completion of the program, leave Bob's door open (10°) to prevent stale air buildup inside the
main chamber. This also reduces energy consumption in standby mode.

3.2 | Standard programs

Bob offers various programs dedicated to: specifi c occasions, different dish types, and different
degrees of staining. Please consult the following overview to fi nd out which program is the best fi t
for your needs.
to pause the current cycle.

At the end of the wash cycle

At this point, the door opens automatically and remains half-open at a 10
degree angle.
Warning Please note that hot steam is released when door opens
Depending on the program, drying might take several minutes, but will not
consume additional energy. The program is not completed yet; please wait
a few minutes for drying to fi nish before removing your dishes.
Warning Please note that some items are very hot and could cause
burns if removed too soon. Daan Tech shall not be responsible for
such incidents, which occur when dishes are removed before the
offi cal end of the cycle.
21