Scope Of Delivery And Spare Parts List; Installation; Transport And Storage; Cleaning And Maintenance - hymer Backrack+ Wheel Holder Sicherheits- Und Montageanleitung

When using the rear carrier system, note that the func-
X
tion of the parking sensors and reversing camera may
be restricted.
Damage caused by swinging open the door
If the door is swung open fully, the load can damage the
shell of the vehicle.
Open the door carefully.
X
SCOPE OF DELIVERY AND SPARE PARTS
LIST
Check delivery for damage and completeness after un-
X
packing. Report any defects to the dealer immediately.

INSTALLATION

Note regarding installation
These instructions describe the installation of the rear
carrier system/accessories on the left-hand rear door.
Installation on the right rear door is just the same. Where
there are differences, these are explicitly referred to in the
respective chapter.
Note regarding screws with thread-locking fluid:
Screw in the screws as far as they will go and tighten
them with the specified torque.
Preparation installation only by specialist dealers.
Required tools
• Torx spanner TX30
• Allen key size 3
• Torque spanner
- Extension
- TX30
Installation
See page 12.
X

TRANSPORT AND STORAGE

Store the rear carrier system / accessories in a dry, clean
X
and frost-free place.

CLEANING AND MAINTENANCE

Tighten the fastening screws at regular intervals.
X
Regularly clean the rear carrier system/accessories with
X
warm water and suitable cleaning agents, at the latest
after exposure to salt water. Do not use aggressive
cleaning agents.
Do not clean the rear carrier system/accessories in car
X
washes.

DISPOSAL

All components of the rear carrier system/accessories are
100% recyclable and can be handed over to appropriate
collection points for recycling.
Dispose of luminaires/lamps properly as electronic
X
waste.
Backrack+ Backrack+
EN
7 7