Technical Data - Meec tools 022936 Bedienungsanleitung/Übersetzung Der Originalanleitung

• Only the tile to be cut should be on the
table or near the table.
• Allow the motor to reach maximum speed
and the blade to rotate freely for a few
seconds before cutting.
• Switch off the tool and pull out the plug if
it makes an abnormal noise, or if the
blade starts vibrating.
• Switch off the tool, pull out the plug and
allow the blade and motor to come to a
complete standstill before removing any
material that has fastened, or to clear
around the blade.
• Never touch the blade or other moving
parts during use.
• If the blade jams, switch off the tool and
pull out the plug before releasing it.
• Never attempt to remove splinters or
pieces before the blade has completely
stopped.
• Make sure that cut pieces are not thrown
up by the blade.
• Never leave the tool before the motor and
blade have completely stopped. Never
leave the tool unattended when it is
plugged in. Switch off the tool and pull
out the plug before leaving it.
• Use the requisite transport devices to
move the tool. Never lift or pull the tool
with the guard.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
Use ear protection.
Wear safety glasses.
Use a face mask.
Pull out the plug/switch off
power supply.
Do not stand on the product.
Tie up long hair. (Do not allow
hair to hang freely, it can fasten
in the rotating tool and result in
personal injury.)
Do not expose to moisture.

TECHNICAL DATA

Rated voltage
Output
Capacity
Spindle thread
Speed 890/1260/1760/2600 /min
Sound power level, L
wA
Sound pressure level, L
Always wear ear protection!
The declared values for vibration and noise, which
have been measured according to a standardised
test method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 61029:2009.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
230 V ~ 50 Hz
400 W
Ø280 x 1000 mm
M18
84 dB(A), K=3 dB
71 dB(A), K=3 dB
pA
EN
33