Setting Option; Charging - Gens Ace Imars Dual Bedienungsanleitung

2.3 Long press the "Channel/Back" button or long press the "confirm" button to quickly end the current
channel task and enter the standy interface.
WARNING: Always check charging parameters before
initiating the charge process. Charging any battery with
improper settings , including charging a battery in the wrong
mode, can result in property damage and fire.
2.4 Long press the "Confirm"button to enter the device setting interface

3. Setting Option

Function setting list
Select task Charge, Discharge, Storage, Balance, ExtDischarge, Digtal Power, SyncCharge
Battery type
Battery voltage
Cell count
Target crrent
Start task

3.1 Charging:

The charger is able to charge batteries with various chemistry. Before charging the battery, please
check that the battery cables is correctly connected to the charger. If the cables are not correctly
connected to the charger, the charger may not be able to charge. LiPo, LiHV, LiFe, Li-ion batteries
must connect the balancing connector to a charger before charging. If the voltage of any cell in the
battery pack is lower than 1.5V, the charger will not be able to charge. After the battery is connected to
the charger, you need to select the corresponding battery connection channel to perform the relevant
settings. The charger can set the type of battery, adjust the parameters such as charging cut-off
voltage, charging current, etc. After the parameters are set, the charger will charge the battery to the
preset voltage and balance it.
Long press Channel
/ Back
Long press Confirm
Long press Confirm
Channel/Back
Confirm
Channel/Back
LiHV，LiPo，Li-Ion，LiFe，NiMH
Set the work completed voltage
Set the series of battery
Set the maximum operating current
Start the work after the setting parameters are completed
WARNING: Always stop the charging cycle or
remove power supplied to the charger if you notice any
irregularities (like a swollen battery) during charging.
09