Synccharging Function Introduction - Gens Ace Imars Dual Bedienungsanleitung

Work interface description:
After entering the work, the display is shown in Figure 5. Click the "Confirm" button to enter the
interface shown in Figure 6 to adjust the power supply voltage and current.
Figure 5

3.6 SyncCharging function introduction

The maximum output power of SyncCharge function is 500W (The power of the external DC input
power supply needs to be more than 550W@20V to meet the max power output, but must be below
700W), and the adjustable range of charging current is 0.1A-23A. When charging, it is necessary to
correctly connect the battery major connector and the balance connector to the charger.
Note: To use the Synccharging mode, you need to use a parallel charging cable (the charger does not
include a parallel charging cable, you may need to purchase it separately), see the diagram below.
Work interface description:
* Set up at the interface shown in Figure 7:
a.Select task b. Battery Type c.Battery voltage d. Cell count e.Target current（Max current)
Figure 7
Figure 6
Balancing Connector
Parallel Charging Cable
11