Device Settings; Firmware Upgrade - Gens Ace Imars Dual Bedienungsanleitung

* The charging interface is as follows：
* After completing the charging, the interface appears as follows：

4. Device Settings

System Setting Menu
Long press the "Confirm" button to enter the device setting interface
System Parameters
Task Parameters
CHA Calibrate
CHB Calibrate
System SelfChecking
System Info
Return

5. Firmware Upgrade

1. If you need to upgrade the firmware of the product, please use the USB cable in the box to connect
the charger to the computer. During the operation, you may need to connect to the Internet to
automatically install the USB driver software;
2. Long press the "Channel/Exit" button of the charger, then connect the charger to the power supply
until the charger emits a "beep" sound, then release the button, double-click to open the upgrade
software, and click "Update" as shown in Figure 1 When the upgrade starts, the charger screen
goes black until the upgrade is complete. During the upgrade process, if the USB is unplugged, the
power is cut off, etc., the upgrade will fail (the original version of the software has been cleared at
this time). As shown in Figure 2, you can repeat steps 1 and 2 above to restart the upgrade.
12
Confirm
Confirm
Language, Max Input Power, Min Input Voltage, BackLight, Volume,
Complete Voice, Factory Reset
Safety Timer, Capacity Limit
Start the device self-test, Do not Connect Battery
Confirm
Confirm
Check device information
Return to the home screen