Discharging; Balance Feature; Extdischarge Function Introduction; Digtalpower Function Introduction - Gens Ace Imars Dual Bedienungsanleitung

3.2 Discharging:

The charger is able to discharge batteries with various chemistry. Before discharging the battery,
please check that the battery cables is correctly connected to the charger. If the cables are not
correctly connected to the charger, the charger may not be able to discharge. LiPo, LiHV, LiFe, Li-ion
batteries must connect the balancing connector to a charger before discharging. If the voltage of any
cell in the battery pack is lower than cut-off valtage, the charger will not be able to discharge. After the
battery is connected to the charger, you need to select the corresponding battery connection channel
to perform the relevant settings. The charger can set the type of battery, adjust the parameters such
as discharging cut-off voltage, discharging current, etc. After the parameters are set, the charger will
discharge the battery to the preset voltage and balance it.

3.3 Balance feature:

The Balance feature of the charger is used to equalize the voltage between the cells, and can be used
to equalize the battery pack with a cell voltage difference greater than 10mV. If any cell of the battery
pack is less than 1.5V, the battery will not be able to perform the balancing work. The charger can
select the ending cut-off voltage in the interface of the balance mode. If the voltage of the cell is lower
than this voltage value, the charger will charge the battery to this voltage and equalize. If the voltage
of the cell is higher than this voltage, the charger will discharge the battery to this voltage and
equalize.

3.4 ExtDischarge function introduction:

First, insert the battery that needs to be discharged into the DC input port of the charger. The
discharge plug of the battery must be an XT60 plug. Then insert the discharger of the external load
into the corresponding channel port. If a resistor is used as a load for discharge, the resistor will
generate a lot of heat. Please pay attention to safety to avoid accidents or personal injury.
Work interface description:
* Set up at the interface shown in Figure 1:
a.Select task b. Battery Type c.Battery voltage d. Cell count e.Target current（Max current)
* After starting the task, the working interface of the product is shown in Figure 2;
* When the external discharge is working, click the "Confirm" button to enter the interface shown in
Figure 4 to adjust the working current;
* After the discharge is completed, the product will enter the interface shown in Figure 3.
Figure 1
Figure 3

3.5 DigtalPower function introduction:

When the digital power supply function is selected, the entire charger is equivalent to an adjustable
power supply, and the voltage and current of the output port can be set. The output port voltage can
be set between 5-29V, and the current can be set between 0.1-15A. The output port cannot be
short-circuited or overloaded, otherwise it will burn the product.
10
Figure 2
Figure 4