Reloop contour Bedienungsanleitung Seite 34

T16
T17
T18
T19
T20
T21
T22
T23
T24
T25
T26
34
Loop shift
By turning the encoder a set loop can
be shifted.
Simultaneously pressing and tur-
ning the encoder determines the
movement's range.
Filter
Regulates the filter effect for the active
deck. In the zero position the filter will
be deactivated automatically.
Pan (Balance) Controller
Herewith you can adjust the volume
division for the left and right channel.
The zero position corresponds to an
equal level on both channels.
Autoloop Function
Sets an automatic loop with the adjus-
ted loop length (-T15-), without having
to manually set the ending point.
Reloop Function
Jumps to the last set loop and reacti-
vates it.
Beat Jump Backward
Carries out a beat jump against oppo-
sed to the playback direction.
Beat Jump Forward
Carries out a beat jump in the playback
direction.
hot Cue Bank select
Selects the desired hot cue bank. If
„1-4" is pressed, the hot cue points 1-4
can be controlled in Traktor. Shortly
pressing „5-8" facilitates the control of
hot cues 5-8 via the Hot Cue Buttons
-T24-.
hot Cue Buttons
Herewith it is possible to control the 8
hot cues of a track in Traktor. Depen-
ding on which bank is currently active
hot cues 1-4 and 5-8 respectively can
be controlled.
If a hot cue is not occupied (no LED
feedback), this hot cue will be assigned
to the current track position by pres-
sing one of the pads.
hot Cue save Button
If this element is pressed, the current
track position is saved on a free hot
cue.
hot Cue Delete Button
While this button is being pressed and
held the saved hot cue points can be
deleted by pressing the corresponding
hot cue pads -T24-. The LED of the
corresponding pad will go out.
Afterwards release the Delete Button in
order to leave delete mode.
TempoBend Control
Allows the temporary acceleration (clockwise)
or deceleration (counterclockwise) of a track.
Cue Mix Fading
Via the Cue Mix Fader a pre-mix can be simula-
ted in your headphones. When to the right the
master signal is audible, when to the left the
cue signal is audible.
Master volume
Adjusts the master volume.
Loop In/set Cue Button
Manually sets the starting point of a loop.
Simultaneously a cue point will be set.
Loop Out Button
Manually sets the ending point of a loop.
Now the deck is in a loop mode, the selected
sequence is permanentely repeated.
Pressing the button again will end the loop
mode.
Left-sided GRID-shift
Shifts the grid that Traktor puts over the bass
line a step to the left.
Right-sided GRID-shift
Shifts the grid that Traktor puts over the bass
line a step to the right.