Reloop contour Bedienungsanleitung Seite 31

Please proceed as follows in order to import the mapping:
1. In Traktor open the adjustment dialogue by clicking the small cog wheel
corner.
2. Open the category „Controller Manager".
3. In order to avoid problems it is recommended to delete all existing entries apart from the key-
board mappings from the controller manager: To do so select one entry after the other in the
field „Device" and press „EDIT..." followed by „Delete".
4. Now select the button „Add..." followed by „Import".
In the selection screen open the mapping file that is found on the CD or that was downloaded from
the Reloop support site.
Troubleshooting
Should a problem arise and Contour's LEDs are not lit correctly, this is probably caused in most
cases by installed MIDI software (e.g. MidiYoke, Maple Virtual MIDI Cable, etc.)
In order to solve the problem proceed as follows:
1. In Traktor open the adjustment dialogue by clicking the small cog wheel
corner.
2. Open the category „Controller Manager".
3. For the following device entries the following port assignments have to be configured:
in the upper right
in the upper right
31