TFA 60.2545 Bedienungsanleitung Seite 12

TFA_No. 60.2545_Anleit_12_22
Radio-controlled alarm clock
3. Elements
A: Display (Fig. 1):
A 1: AM/PM clock
A 3: Seconds
A 5: Alarm symbol
A 7: AM/PM Alarm time
A 9: Temperature
B: Buttons (Fig. 1+2):
B 1: TIME button
B 3: + button
B 5: WAVE button
B 6: SNOOZE/LIGHT sensor button
B 7: ALARM ON/OFF button
C: Housing (Fig. 2):
C 1: Battery compartment
22
15.12.2022 14:51 Uhr
A 2: Time
A 4: DCF reception symbol
A 6: Snooze symbol
A 8: Alarm time/date
B 2: ALARM button
B 4: – button
Seite 12
Radio-controlled alarm clock
4. Getting started
• Open the battery compartment and insert two new AAA 1,5 V
batteries. Make sure the polarity is correct.
• Close the battery compartment again.
• The device will alert you with a beep and all segments will be
displayed for a short moment.
• The clock will now scan the DCF frequency signal and the DCF
symbol will be flashing on the display. When the time code
is successfully received after 3-7 minutes, the radio-controlled
time, the date and the DCF symbol will be shown steadily on
the display.
• The DCF reception always takes place daily at 1:00, 2:00 and
3:00 o'clock in the morning. If the reception fails, it will repeat
again at 4:00, 5:00 and 6:00 o'clock.
• Press and hold the WAVE button for three seconds and start
the initialisation manually. To stop the DCF reception attempt,
press the WAVE button again.
23